1. Rolls of membrane are layd and positions with siliconical foil in the bottom side.
|
2.
Remove the siliconical foil stipulated the bottom, and press by easy ironing with foot. The membrane join the support layer .
|
3. It cut the sprue.
|
4. Lies the next membrane roll, overlapping the longitudinal 10 cm side over the siliconical foil side.
|
5. Detached the siliconical foil provided on the lower side and siliconical foil on the lateral side. Press with foot the overlapping lateral membrane side.
|
6. Heat up the membrane, with the burner on top of the membrane, until melting the protection foil. Applies the polystyrene to the surface of membrane and the press with foot. The thermo- additives will set perfectly, in total adherence the polystyrene to the membrane surface. At the same time, the membrane, adhere fully to the support layer, playing the role of
"vapor barrier".
|
7. Applies the new ARCO THERMO AD layer, in a manner similar to the one shown above. It recommended a easy heating, on top of the membrane and a pressing the surface membrane and the overlaps side.
|
8. Applies final layer of protection with mineral membrane by heat flame, in total adherence. At this time, the THERMO AD layer will fully paste withe the polystyrene.
|
9. Details of execution :
|